Surface resistance meter esd meter ae-790

Description

ARMEKA AE-790 STATIC METER Static Electricity Power meter Static electricity detector AE-790 Static Electricity Tester

FEATURES.

-Quick visual display of static from 0-19,990 volts.

-Touch to test static in both positive and negative polarity.

-Easy to ground by touching 10mm snap contact.

-Low battery indicator built into liquid crystal display (LCD).

-Micro-power circuits 9-volt alkaline battery for approximately six months.

-Conductive static-safe carrying case with protective foam anti-static

-Detects how much static a person is carrying.

-Audits any potential generator or disspater

Wrist straps, heel grounders, toe straps, static-safe shoes, chairs, table mats, floor mats, ground leads,

purpose-built floors, garments, static sprays, floor finishes

or materials, etc.

INTRODUCTION.

The AE-790 Stati-Check Meter is a simple, easy-to-use and inexpensive unit that shows how much

static is present on the person This unit can be held in

the hand or mounted to a wall. The AE-790 Stati-Check Meter is the all-around audit tool for your

protection against static.

OPERATION

Before using the AE-790 Static-Check Meter for any of the below tests, ground the meter using the

provided six-foot cord. The cord has a 10mm snap at the end and a 4mm banana plug at the other end.

The 10mm snap and the 4mm banana plug are a common ground on the AE-790 Stati-Check Meter.

NOTE: Failure to inconsistent results. If the AE-790 Stati-Check Meter is not

grounded, a charge is produced, resulting in inconsistent readings. The circuit will only become

responsive when offered a path to ground.

Standard Test

To check for a static charge or build up, simply set the unit in a

convenient place and press to the "Touch to rectangular" plate. The LCD will display a

range of "0000" volts to "19,990" volts on the LCD

undergoing the test. Then touch the 10mm stud next to the word "Ground". This will discharge any static

charge immediately.

Testing Other Items

A. Wrist strap and cord: Connect the 10mm snap into the stud stud on the AE-790. Stati-Check

Meter. Shuffle feet while touching the "Touch to Test" rectangular plate. If the wrist strap and cord

are functioning properly, the AE-790 Stati-Check Meter will display "0000" volts on the LCD.

Disconnect the wrist strap from the cord and repeat the test

feet again. Of several thousand volts of static.