Surface resistance meter esd meter ae-780a

Description

ARMEKA AE-780A ESD Meter, ESD Tester, Checker, Static electricity tester. ARMEKA AE-700 Surface resistance meter, surface resistance meter, electrostatic meter Electrostatic measuring instruments Static electricity checker ESD tester, ESD tester.

The surface resistance material of the ESD material has a measurement of 103 ohms to 10v-1212 ohms. The surface resistance meter is 10Ω-1212Ω.

    By using ASTM standards for testing using LED lights, showing measurement values. It is based on ASTM Standard D257 testing method. indicate the result of resistance.

    It is the test results from the Surface Resistance Meter but not according to IEC61340-1-1 / 2.

    The AE-780ASurface Resistance Checker is a portable battery powered fitted with built-in parallel electrodes that allow for tests of material surface resistance. This device is designed for quick checks of surface resistance applications in electronics manufacturing or handling environments. The Surface Resistance Checker is equipped with an automatic test voltage selector. The voltage will switch test from 10V to 100V should the measured resistance exceed 1 x 10E5 ohms. Two banana jacks and an electrode toggle switch allow for connection of external 5 pound electrodes that measure surface resistance (RPP) or resistance to equipment ground (RTG).

Compliance Verification Plan "A Compliance Verification Plan shall be established to ensure the ESD Control Program Process monitoring (measurements) will be conducted in accordance with the compliance plan. Those verifications shall occur. The Compliance Verification Plan If the test methods used by the organization differ from any standards referenced in this document, then there must be a tailoring statement that is part of the ESD Control Program. Compliance verification records shall be established and maintained to provide evidence of conformity to the technical requirements.

GENERAL GUIDELINES.

• Use both 5 pound electrodes for RPP.

• Use one 5 pound electrode and one to ground for RTG (note: groundable points are usually snaps installed on the material or workstation common point ground).

• ensure that the item being measured is an electrically isolated

• Ensure that the test leads are separated as a best practice.

• When using the 5 pound electrodes.

• Place no closer than 2 "from the edge of the surface being measured.

• Place no closer than 3 "to any groundable point.

• Place the 5 pound electrodes about 10 "apart for the RPP of worksurface and 3’ for floor.

• Preferred placements include: most commonly used surface area, most worn, center, and furthest from groundable point.

• For RTG, connect the banana plug to groundable point.

• If surface has sections (floor tiles, garment panels), for RPP place 5 pound electrodes on different sections.

ARMEKA expressly warrants that for a period of one (1) year from the date of purchase ARMEKA Surface Resistance Checkers will be free of material (parts) and workmanship (labor). Within the warranty period, a credit for purchase of replacement ARMEKA Surface Resistance Checkers, or, at ARMEKA’s option, the Surface Resistance Checker will be repaired or replaced free of charge. If product credit is issued, the amount will be calculated by multiplying the unused portion of the expected one year life times the original unit purchase price. Call our Customer Service Department at 00358 208 405 488 （Finland） or 0086 769 81331736 (China) for a Return Material Authorization (RMA) and proper shipping instructions and address. Please include a copy of the invoice for the invoice, or other proof of date. Any unit under warranty should be shipped to the ARMEKA factory. Warranty replacements will take approximately two weeks.