Power supply regulator for electric power model clt-50at

Power supply regulator for electric power model clt-50at

for TLF Electric Screwdriver.

Operation instructions.

1.This unit can be used to count the quantity of finished products and number of screws to be locked in a single product.

2.Make sure the input power and input signal are correct before use.

3.Press the key [PRE SET] to set the number of screws to be locked for finished products. The relevant value will be shown at [screw count display window].

4.Check the value at [finished product counting display window] to be confirmed by the user. For reset, you may press the key [CLEAR] (SW1/ON position).

5.Set the operation judge time for screw lock set (interval between two lock screws in the same work piece, (SW5/ON position). The fine cross head driver adjustment [GAP ADJ.] can be used at a time confirmed by the user (0.2~3.0 seconds).

6.In operation, each time receiving the signal from the lock brake of the screw control, the [SIGN] light of this unit will turn on, and the value at [screw count display window] will auto reduce by one (count down).

7.In continuous normal operation, when the value at [screw count display window] is reduced to zero, the value at [finished product counting display window] will auto increase by one, (At position SW4/ON, there will be beep sound) and the value at [screw count display window] will return to the preset value.

8.When the screw lock is poor and needs to re-operate, press the key [DEC.COU], the value at [screw count display window] will increase by one (until the preset value) (SW3/ON position).

9.When it is required to reset the lock screw number on the work piece to preset value, press the key [RESET] (SW2/ON position).

Santa Technology Company Limited (Headquarters)
35/218 Moo 2, Liab Klong Sam Road, Klong Sam Subdistrict, Khlong Luang District Pathumthani 12120
Call 02-101-3454, 089-006-2766
Fax 02-101-3453
Mail. [email protected]
Line: @santatech
Web: https://santatechnology.com/