Amada miyachi welding transformer ct-110d cy-210d
Amada Miyachi Welding Transformer CT-110D CY-210D
Our team will contact you with a quotation within 24 hours.
Product details
Amada miyachi welding transformer ct-110d cy-210d
Model:CY-210D CT-110D
Power requirements for welding power supply:220 / 230 / 240 / 380 / 400 / 415 / 440 / 460 / 480VAC -25% +10%, 50/60Hz
Power requirements for control power supply:100 / 120 / 220 / 230 / 240VAC +/-20%, 50/60Hz
Control method:Primary or secondary current feedback type constant current control through thyristor phase control or Power requirements fluctuation compensation control type
Timer setting:15 schedules
"SQUEEZE," "WELD II," "COOL II," "WELD III," "SLOPE II," "HOLD," "OFF" 00 - 99cycles
"SLOPE I," 0 - 9cycles
"WELD I" "COOL I" 0 - 9cycles "WELD I" "COOL I" 00 - 99cycles
Pulsation count:Switching used with Off mode 0 - 9 times
Current setting range:1.0 - 80.0kA (Maximum current setting: 5.0 - 80.0kA)
Control speed:Secondary current feedback type constant current control 1/2 cycle (Requires toroidal coil)
Primary current feedback type constant current control 1cycle (Requires CT coil)
Power requirements fluctuation compensation control 1cycle
Current accuracy:For secondary current feedback type constant current control
a) ±2% max. of welding power supply voltage fluctuation +10% -15%(Accuracy based on error relative to full scale.)
b) ±2% max. of resistance load fluctuation ±15%(Accuracy based on error relative to full scale.)
c) ±2% max. of induction load fluctuation ±15%(Accuracy based on error relative to full scale.)
Weld force output:Either 2-series control power supply voltage (1A max.) or 24VDC (0.6A max.)
Step up:2 series, 9 stages1 series, 9 stages
Counter 0 - 9999
Current increase ratio 50 - 200% of the set current in 1% step
External input signals: INTERLOCK/COUNT RESET (dip-switch-selectable):If a closed-contact signal is input,the system waits for the power to be turned on or the count to be reset.(For CY-210D)
INTERLOCK/WELD No. SET (dip-switch-selectable):If a closed-contact signal is input, the system waits for the power to be turned on when the interlock function is selected.(For CY-110D)
External output signals: INTERLOCK/COUNT UP (dip-switch-selectable):Outputs from 2 cycles from when the power is turned on until the power is turned off, or outputs when the counter expires(contact capacity: 110 V AC, 0.5 A) (For CY-210D)
INTERLOCK/WELD No. ERROR (dip-switch-selectable): Output from 2 cycles before the power is turned on until the power is turned off, or when a weld-count error occurs(contact capacity: 110 V AC, 0.5 A) (For CT-110D)
Error output:Self-diagnosis error
Start input error
Current-setting error
Current stepper-up ratio setting error
Thermostat error
Thyristor short-circuit error
No-power-supply error
Current upper-and-lower-limit error
Cond. angle error
Full-wave error
Total counter-up
Insufficient weld count (CY-210D Only)
Step-up completion
Mass :4.5kg
